Building a greenhouse

Each palm tree has its own miniature greenhouse. The frame was constructed using PVC pipe. The outer frame is 3/4" schedule 40 electrical conduit. The electrical conduit is much cheaper than the PVC pipe used for drains. It also seemed more flexible. I used the elbows and tees from the plumbing fittings since there is a better selection.

The side arc is glued together as one piece. I just bent the pvc in a u-shape and glued cross-braces with pvc glue. The tees that connect the two arcs are 1"x1"x3/4 tees that slide over the arc so I can adjust them. The cross pieces are glued into one side, but are screwed into the other. This way I can take the two sides apart and store them flat.

I covered the arc with green mesh plastic fencing to give it stability for a snow load. The mesh is attached with plastic zip ties so it is easy to remove.

I used some leftover political yard signs to harvest some very stiff metal wire. I bent it in a u-shape and used it to anchor the pvc tubing to the ground. I also built a wood frame around the bottom to attach the plastic and keep the wind from blowing under the greenhouse.

The base of the tree is wrapped in burlap to keep it warm. I will also be installing heaters, heater controllers, lights, and thermometers.